Building

When mounting the stand construction or substructure

A spirit level as long as possible, a carpenter's lead and the measuring tape are required to define and mark the course of a partition or ceiling substructure. A powerful cordless screwdriver, a drill or impact wrench with correspondingly sized drill sizes are also required for this, sometimes a second pair of hands when installing ceiling beams - unless you work with direct hangers.

In any case, even a small hammer should be ready. If the UW profiles are to be attached to the floor by gluing instead of screws, silicone is also needed in a silicone syringe. Some tape for attaching the lintel profile if necessary and a sharp knife (cutter) for separating the tape.

When mounting the gypsum plasterboard

Here, above all, a sharp utility knife with sufficient replacement blades are needed, a metal strip for scoring the breaking edge, who likes to work with a fine fox tail, a hole saw attachment for the drill or a jigsaw - Hole saw attachment clearly works the fastest. An edge planer, which is also suitable for chamfering the plates should also be ready. To break the GK panels should also somewhere near a table with an exactly straight, stable edge stand. Measuring tape and spirit level, which can also be used to scribble before cutting, should always be within reach. A small shoulder bag for a handful of screws has proven itself while fixing the plates. Also provide the power tool to lay the cables if necessary.

For grouting and finishing

Fillers, silicone syringes, fine sanding paper or orbital sanders and, if necessary, buckets, tubs and rubber cups are required to apply joint filler, plaster or paint. A stirrer is not wrong, for plastering you need a small trowel, preferably a Venetian trowel, or roll-on a lambskin scooter and a drip tray, both can then be used for painting. Deep ground for priming is best done with a quast.

Share with friends

Leave your comment